来自 IT技术新闻 2018-10-22 10:00 的文章

CentOS 6.3下部署LVS实现高性能高可用负载均衡

一、简介

VS/NAT原理图:

AAAAAA>二、系统环境

实验拓扑:

系统平台:CentOS 6.3

Kernel:2.6.32-279.el6.i686

LVS版本:ipvsadm-1.26

腾讯娱乐keepalived版本:keepalived-1.2.4

三、安装

0、安装LVS前系统需要安装popt-static,kernel-devel,make,gcc,openssl-devel,lftp,libnl*,popt*

1、在两台Director Server上分别配置LVS+Keepalived

LVS install -------------

[[email protected]_MASTER ~]# wget http://www.linuxvirtualserver.org/software/kernel-2.6/ipvsadm-1.26.tar.gz

[[email protected]_MASTER ~]# ln -s /usr/src/kernels/2.6.32-279.el6.i686//usr/src/linux/

[[email protected]_MASTER ~]# tar zxvf ipvsadm-1.26.tar.gz

[[email protected]_MASTER ~]# cd ipvsadm-1.26

[[email protected]_MASTER ipvsadm-1.26]# make && make install

Keepalived install -------------

[[email protected]_MASTER ~]# wget http://www.keepalived.org/software/keepalived-1.2.4.tar.gz

[[email protected]_MASTER ~]# tar zxvf keepalived-1.2.4.tar.gz

[[email protected]_MASTER ~]# cd keepalived-1.2.4

[[email protected]_MASTER keepalived-1.2.4]# ./configure && make && make install

#########将keepalived做成启动服务,方便管理##########

[[email protected]_MASTER ~]# cp /usr/local/etc/rc.d/init.d/keepalived /etc/init.d/

[[email protected]_MASTER ~]# cp /usr/local/etc/sysconfig/keepalived /etc/sysconfig/

[[email protected]_MASTER ~]# mkdir /etc/keepalived/

[[email protected]_MASTER ~]# cp /usr/local/etc/keepalived/keepalived.conf /etc/keepalived/

[[email protected]_MASTER ~]# cp /usr/local/sbin/keepalived /usr/sbin/

[[email protected]_MASTER ~]# service keepalived start | stop

2、开启路由转发

[[email protected]_MASTER ~]# vim /etc/sysctl.conf
net.ipv4.ip_forward = 1
[[email protected]_MASTER ~]# sysctl -p

3、配置Keepalived

[[email protected]_MASTER ~]# less /etc/keepalived/keepalived.conf

! Configuration File for keepalivedglobal_defs {   router_id LVS_MASTER #BACKUP上修改为LVS_BACKUP }vrrp_instance VI_1 {    state MASTER #BACKUP上修改为BACKUP interface eth0    virtual_router_id 51    priority 100 #BACKUP上修改为80 advert_int 1    authentication {        auth_type PASS        auth_pass 1111    }    virtual_ipaddress {        10.0.0.227    }}vrrp_instance LAN_GATEWAY {    state MASTER #BACKUP上修改为LVS_BACKUP interface eth1    virtual_router_id 52    priority 100 #BACKUP上修改为80 advert_int 1    authentication {        auth_type PASS        auth_pass 1111    }    virtual_ipaddress {        192.168.10.10    }}virtual_server 10.0.0.227 80 {    delay_loop 6    lb_algo rr    lb_kind NAT#   persistence_timeout 5    protocol TCP    real_server 192.168.10.4 80 {        weight 3        TCP_CHECK {            connect_timeout 3            nb_get_retry 3            delay_before_retry 3            connect_port 80        }    }        real_server 192.168.10.5 80 {        weight 3        TCP_CHECK {            connect_timeout 3            nb_get_retry 3            delay_before_retry 3            connect_port 80        }    }}

BACKUP服务器同上配置,先安装lvs再安装keepalived,然后配置/etc/keepalived/keepalived.conf,只需将批注部分改一下即可。

4、分别在2台Real Server上面设置网关

把网关都设置成:192.168.10.10

5、在2台RealServer中分别配置HTTAAAAAAA>[[email protected] ~]# yum -y install httpd
[[email protected] ~]# cd /var/www/html/
[[email protected] html]# cat index.html
<h1>WEB1/192.168.10.4</h1>
[[email protected] html]# /etc/init.d/httpd start
另一台机器配置一样,过程略。

6、分别在CentOS-LVS_MASTER、CentOS-LVS_BACKUP上执行service keepalived start启动keepalived就可实现负载均衡及高可用集群了;

[[email protected]_MASTER keepalived]# service keepalived start

四、测试

####高可用性测试####

模拟故障,将CentOS-LVS_MASTER上的keepalived服务停掉,然后观察CentOS-LVS_BACKUP上的日志,信息如下

从日志中可知,主机出现故障后,备机立刻检测到,此时备机变为MASTER角色,并且接管了主机的虚拟IP资源,最后将虚拟IP绑定在etho设备上。

将CentOS-LVS_MASTER上的keepalived服务开启后,CentOS-LVS_BACKUP的日志状态。

从日志可知,备机在检测到主机重新恢复正常后,释放了虚拟IP资源重新成为BACKUP角色

####故障切换测试####

故障切换是测试当某个节点出现故障后,Keepalived监制模块是否能及时发现然后屏蔽故障节点,同时将服务器转移到正常节点来执行。

将WEB2节点服务停掉,假设这个节点出现故障,然后主、备机日志信息如AAAAAAA>

从以上可以看出,Keepalived监控模块检测到192.168.10.5这台主机出现故障后,将WEB2从集群系统中剔除掉了。此时访问http://10.0.0.227只能看到WEB1了)

重新启动WEB2节点的服务,日志信息如下:

Keepalived监控模块检测到192.168.10.5这台主机恢复正常后,又将此节点加入集群系统中,再次访问就可以访问到WEB2页面了)

http://www.bkjia.com/Linux/773678.htmlwww.bkjia.comtruehttp://www.bkjia.com/Linux/773678.htmlTechArticle一、简介 VS/NAT原理图: 二、系统环境 实验拓扑: 系统平台:CentOS 6.3 Kernel:2.6.32-279.el6.i686 LVS版本:ipvsadm-1.26 keepalived版本:keepalived-1.2...

本文源自: AG88平台